1.INSTALL STEERING COLUMN ASSEMBLY
Install the steering column with the 3 bolts.
2.INSTALL STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Install the cover with the 3 bolts.
3.CONNECT CONNECTOR
Connect the connectors and attach the wire harness clamps.
4.CONNECT STEERING SLIDING YOKE
5.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
6.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)
| *1 | Clamp |
| *2 | Claw |
Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable sub-assembly to the steering column assembly.
Connect the connectors to the combination switch assembly with spiral cable sub-assembly.
7.INSTALL COMBINATION SWITCH ASSEMBLY (w/o Airbag System)
Refer to the step "INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY".
Attach the 3 claws install the horn contact plate to the combination switch assembly.
8.INSTALL STEERING COLUMN UPPER COVER
Attach the claw to install the upper cover.
9.INSTALL STEERING COLUMN LOWER COVER
Install the lower cover with the 3 screws.
10.INSTALL STEERING WHEEL ASSEMBLY
11.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
13.CHECK SRS WARNING LIGHT (w/ Airbag System)