1.INSTALL ANTENNA WITH HOLDER ASSEMBLY (for Double Cab)
Attach the 2 claws to install the with holder antenna assembly.
Install the nut.
Attach the cable to the 3 clamps.
Make sure the cable of the antenna passes behind pin A.
Connect the connectors.
2.INSTALL ANTENNA WITH HOLDER ASSEMBLY (for Extra Cab)
Attach the 2 claws to install the with holder antenna assembly.
Install the nut.
Connect the connectors.
3.INSTALL ROOF HEADLINING ASSEMBLY
for Extra Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Extra Cab)>INSTALLATION)
for Double Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>INSTALLATION)
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).