Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE UPPER BACK PANEL GARNISH
4.REMOVE REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)
5.REMOVE REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)
6.REMOVE LOWER BACK PANEL GARNISH
7.REMOVE REAR SEATBACK ASSEMBLY
8.REMOVE FRONT DOOR SCUFF PLATE LH
9.REMOVE FRONT DOOR WEATHERSTRIP LH
10.REMOVE QUARTER INSIDE TRIM BOARD LH
11.REMOVE REAR SPEAKER ASSEMBLY
Disconnect the connector.
Remove the 3 screws and speaker.