Home › Power Source / Network › 1KD-FTV BATTERY / CHARGING › GENERATOR(for DENSO Made) › 2011.10–2012.01
RM1840EF _57 Power Source / Network _009635 1KD-FTV BATTERY / CHARGING _0052669 GENERATOR(for DENSO Made) A

1KD-FTV BATTERY / CHARGING  GENERATOR(for DENSO Made)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL GENERATOR ASSEMBLY

A195391
1.906,1.938 2.115,2.135 0.208,0.198 10 true A 2.198,2.458 2.448,2.677 0.25,0.219 10 true B

a.

Install the generator with the 2 bolts.

Torque:
for bolt A : 62 N*m (632 kgf*cm, 46 ft.*lbf)
for bolt B : 25 N*m (255 kgf*cm, 18 ft.*lbf)


b.

Install the generator wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the generator connector.


Hide 2.INSTALL NO. 2 IDLER PULLEY ASSEMBLY

a.

Install the spacer, No. 2 idle pulley and pulley plate with the bolt.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).