1.INSTALL GENERATOR ASSEMBLY
Install the generator with the 2 bolts.
Install the generator wire with the nut.
Connect the generator connector.
2.INSTALL NO. 2 IDLER PULLEY ASSEMBLY
Install the spacer, No. 2 idle pulley and pulley plate with the bolt.
3.INSTALL FAN AND GENERATOR V BELT
4.INSTALL AIR CLEANER ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).