Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH › 2012.01–2012.04
RM1840EF _58 Vehicle Interior _009640 DOOR LOCK _0052685 UNLOCK WARNING SWITCH A

DOOR LOCK  UNLOCK WARNING SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 4.REMOVE STEERING COLUMN LOWER COVER

Hide 5.REMOVE STEERING COLUMN UPPER COVER

Hide 6.REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

Hide 7.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY

Hide 8.REMOVE UNLOCK WARNING SWITCH ASSEMBLY

a.
B281347

Disconnect the unlock warning switch connector.


b.

Detach the 2 claws and slide the unlock warning switch as shown in the illustration.


c.
B281348
1.51,0.969 2.083,0.271 2.083,0.271 2.281,0.271 true 2.323,0.177 2.792,0.406 0.469,0.229 10 false *1
*1 Pin


Push in the pin, slide the unlock warning switch as shown in the illustration and remove it.