Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2012.04–2012.10
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052711 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


PROCEDURE

Hide 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 2.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 3.REMOVE LOWER STEERING COLUMN COVER

Hide 4.REMOVE UPPER STEERING COLUMN COVER

Hide 5.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B283186

Disconnect the connectors.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



b.

Detach the 3 claws and remove the spiral cable sub-assembly.

NOTICE:
·

Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Do not rotate the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Make sure the steering wheel assembly is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).

·

Do not remove the steering angle sensor from the spiral cable sub-assembly.