Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
Align the outer belt positioning holes with the claws and install the retractor of the front seat outer belt assembly LH with the bolt.
Install the front seat outer belt shoulder anchor with the bolt.
Close the cover and attach the 2 claws.
2.INSTALL LOWER QUARTER TRIM PANEL LH
Attach the 3 clips, claw and 2 guides to install the lower quarter trim panel LH.
Install the front seat outer belt floor anchor with the bolt.
3.INSTALL FRONT DOOR OPENING TRIM LH
4.INSTALL FRONT DOOR SCUFF PLATE LH
5.INSTALL FRONT SEAT ASSEMBLY
for Separate Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>INSTALLATION)
for Bench Seat Type:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION)