Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Align the seat outer belt positioning holes with the claws and install the retractor of the rear seat outer belt assembly LH with the bolt.
Install the shoulder anchor with the bolt.
Attach the 2 claws to close the cover.
| *a | Front |
| *b | RH |
| *c | 90 +- 45° |
Install the floor anchor with the bolt, as shown in the illustration.
2.INSTALL LOWER QUARTER TRIM PANEL LH
3.INSTALL REAR DOOR OPENING TRIM LH
4.INSTALL REAR DOOR SCUFF PLATE LH
5.INSTALL REAR SEAT ASSEMBLY