Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR › from 2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052758 AIR CONDITIONING PRESSURE SENSOR A

HEATING / AIR CONDITIONING  AIR CONDITIONING PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

a.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioning tube and accessory assembly (air conditioning pressure sensor).

Compressor oil:

ND-OIL 8 or equivalent



b.

Install the 2 O-rings to the air conditioning tube and accessory assembly (air conditioning pressure sensor).


c.

Install the air conditioning tube and accessory assembly with the 3 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Connect the connector.


Hide 2.INSTALL INTAKE AIR CONNECTOR AND AIR CLEANER ASSEMBLY (for TR Series Engine)

Hide 7.INSTALL RADIATOR SIDE DEFLECTOR RH

a.

Install the radiator side deflector RH with the 3 clips.


Hide 8.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

Hide 9.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)

Hide 10.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)

Hide 11.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)

Hide 12.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

Hide 13.INSTALL NO. 1 ENGINE UNDER COVER (except 4WD and Pre-Runner)

Hide 16.ADJUST FOG LIGHT AIMING (w/ Fog Light)