Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY(for Heater) › from 2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052760 RELAY(for Heater) A

HEATING / AIR CONDITIONING  RELAY(for Heater)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 HEATER RELAY

a.

Install the No. 1 heater relay.


b.

Attach the clamp to install the driver side junction block.


c.

Install the 2 nuts.


Hide 2.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).