Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door) › 2012.01–2012.04
RM1840EF _59 Vehicle Exterior _009651 WINDOW / GLASS _0052786 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH

Hide 5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 6.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 7.REMOVE REAR DOOR NO. 2 TRIM BRACKET

Hide 8.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 9.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 11.REMOVE REAR DOOR GLASS RUN LH

Hide 12.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 13.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
B282456

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.