Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY(for Double Cab) › 2011.10–2012.01
RM1840EF _59 Vehicle Exterior _009652 DOOR / HATCH _0052795 FUEL LID LOCK CONTROL CABLE ASSEMBLY(for Double Cab) A

DOOR / HATCH  FUEL LID LOCK CONTROL CABLE ASSEMBLY(for Double Cab)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 2.REMOVE FRONT SEAT ASSEMBLY RH

a.

for Manual Seat:

HINT:

Use the same procedure described for the LH side.




Hide 4.REMOVE CONSOLE BOX ASSEMBLY (w/ Console Box Lid)

Hide 7.REMOVE COWL SIDE TRIM BOARD LH

B277609

a.

Remove the part of the front door opening trim attached to the cowl side trim board.


b.

Remove the clip.


c.

Detach the 2 clips and remove the cowl side trim board.


Hide 9.REMOVE LOWER CENTER PILLAR GARNISH LH

a.
B276978

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B276929

Remove the part of the front door opening trim and rear door opening trim attached to the lower center pillar garnish.


c.

Detach the 2 claws, 2 guides and 2 clips and remove the lower center pillar garnish.


Hide 10.REMOVE LOWER QUARTER TRIM PANEL LH

B276982

a.

Remove the part of the rear door opening trim attached to the lower quarter trim panel.


b.

Detach the claw and 3 clips and remove the lower quarter trim panel.


Hide 11.REMOVE FRONT FLOOR CARPET ASSEMBLY

a.

Partially remove the floor carpet.

HINT:

It is not necessary to fully remove the floor carpet. Partially remove it so that the lock control cable can be removed in a later step.



Hide 12.REMOVE REAR NO. 1 WHEEL OPENING EXTENSION SUB-ASSEMBLY LH (w/ Over Fender)

Hide 13.REMOVE REAR WHEEL HOUSE LINER LH

a.

Partially remove the liner.

HINT:

It is not necessary to fully remove the liner. Partially remove it so that the lock control cable can be removed in a later step.



Hide 14.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY

a.

Remove the fuel lid lock open lever.


b.

Remove the grommet from the vehicle body.


c.

Detach the cable from the clamps shown in the illustration.

B278268
5.271,1.333 5.531,0.385 5.531,0.385 5.365,0.385 true 1.24,7.021 1.417,7.146 false 4.042,4.729 4.531,5.104 true 3.74,5.135 3.823,5.438 false 3.427,5 2.771,4.667 true 5.208,0.292 5.396,0.5 0.188,0.208 10 false *1 1.313,0.74 1.5,0.948 0.188,0.208 10 false *2 5.01,6 5.188,6.219 0.177,0.219 10 false C 2.76,6.01 2.938,6.229 0.177,0.219 10 false B 0.427,5.99 0.604,6.208 0.177,0.219 10 false A 1.458,7.115 1.646,7.323 0.188,0.208 10 false *2 2.604,4.573 2.781,4.792 0.177,0.219 10 false A 3.792,5.448 4.021,5.688 0.229,0.24 10 false B 4.583,5.063 4.76,5.281 0.177,0.219 10 false C
*1 Fuel Lid Lock Open Lever *2 Grommet



d.
B277114

Turn the fuel filler opening lid lock retainer counterclockwise and remove the fuel lid lock control cable from the fuel filler opening lid lock retainer.


Hide 15.REMOVE FUEL FILLER OPENING LID LOCK RETAINER

B277116

a.

Turn the fuel filler opening lid lock retainer clockwise and remove the fuel filler opening lid lock retainer as shown in the illustration.