1.REMOVE FRONT SEAT ASSEMBLY LH
2.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
3.REMOVE CONSOLE BOX ASSEMBLY
4.REMOVE REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)
5.REMOVE REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)
6.REMOVE UPPER BACK PANEL GARNISH
7.REMOVE REAR SEATBACK ASSEMBLY
8.REMOVE LOWER BACK PANEL GARNISH
9.REMOVE FRONT DOOR SCUFF PLATE LH
10.REMOVE COWL SIDE TRIM BOARD LH
Remove the part of the front door opening trim attached to the cowl side trim board.
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
11.REMOVE QUARTER INSIDE TRIM BOARD LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the part of the front door opening trim attached to the quarter inside trim board.
Detach the 4 claws, 3 guides and 7 clips and remove the quarter inside trim board.
12.REMOVE FRONT FLOOR CARPET ASSEMBLY
Partially remove the floor carpet.
It is not necessary to fully remove the floor carpet. Partially remove it so that the lock control cable can be removed in a later step.
13.REMOVE REAR NO. 1 WHEEL OPENING EXTENSION SUB-ASSEMBLY LH (w/ Over Fender)
14.REMOVE REAR WHEEL HOUSE LINER LH
Partially remove the liner.
It is not necessary to fully remove the liner. Partially remove it so that the lock control cable can be removed in a later step.
15.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Remove the fuel lid lock open lever.
Remove the grommet from the vehicle body.
Detach the cable from the clamps shown in the illustration.
| *1 | Fuel Lid Lock Open Lever | *2 | Grommet |
Turn the fuel filler opening lid lock retainer counterclockwise and remove the fuel lid lock control cable from the fuel filler opening lid lock retainer.
16.REMOVE FUEL FILLER OPENING LID LOCK RETAINER
Turn the fuel filler opening lid lock retainer clockwise and remove the fuel filler opening lid lock retainer as shown in the illustration.