Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Power Window)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)
4.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
5.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
6.REMOVE DOOR PULL HANDLE
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
9.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH
10.REMOVE FRONT DOOR NO. 1 TRIM BRACKET
11.REMOVE FRONT DOOR SERVICE HOLE COVER LH
12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
13.REMOVE FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH
| *A | for Double Cab |
| *B | for Single Cab |
| *1 | Protective Tape |
Put protective tape around the front door outer glass weatherstrip.
Detach the 5 claws and remove the front door outer glass weatherstrip.