Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052656 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly*1 or steering pad switch LH*2 to the radio receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio receiver assembly cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2, and the radio receiver assembly itself cannot function.

*1: w/ Accessory Meter

*2: w/o Accessory Meter


WIRING DIAGRAM

C240167
5.823,2.76 6.073,2.969 0.25,0.208 10 false 22 5.823,1.74 6.031,1.917 0.208,0.177 10 false 23 5.823,0.729 6.042,0.938 0.219,0.208 10 false 21 5.5,2.76 5.677,2.938 0.177,0.177 10 false 5 4.625,2.76 4.802,2.938 0.177,0.177 10 false 9 5.5,1.74 5.677,1.917 0.177,0.177 10 false 4 4.625,1.74 4.802,1.917 0.177,0.177 10 false 8 5.5,0.729 5.677,0.906 0.177,0.177 10 false 6 4.656,3.604 5.021,3.875 0.365,0.271 10 false G12 6.021,3.604 6.365,3.833 0.344,0.229 10 false G1 2.719,2.094 3.219,2.313 0.5,0.219 10 false MODE 6.135,2.865 6.615,3.135 0.479,0.271 10 false SW2 6.135,1.854 6.688,2.135 0.552,0.281 10 false SWG 6.135,0.854 6.594,1.104 0.458,0.25 10 false SW1 4.979,2.771 5.396,3.021 0.417,0.25 10 false AU2 4.979,1.75 5.458,1.979 0.479,0.229 10 false EAU 4.979,0.719 5.385,0.958 0.406,0.24 10 false AU1 2.75,1.083 3.354,1.302 0.604,0.219 10 false Seek+ 2.135,1.083 2.646,1.271 0.51,0.188 10 false Seek- 1.344,1.083 2.115,1.344 0.771,0.26 10 false Volume+ 0.667,1.083 1.406,1.313 0.74,0.229 10 false Volume- 4.583,0.729 4.854,0.969 0.271,0.24 10 false 10 6.021,3.771 7,4.281 0.979,0.51 10 false Radio Receiver Assembly 4.656,3.771 5.573,4.302 0.917,0.531 10 false Spiral Cable Sub-assembly 1.333,3.698 3.438,3.979 2.104,0.281 10 false Steering Pad Switch Assembly*1 1.344,3.51 1.677,3.76 0.333,0.25 10 false z3 1.323,3.969 3.427,4.25 2.104,0.281 10 false Steering Pad Switch LH*2 0.063,4.427 1.802,4.677 1.74,0.25 10 false *1: w/ Accessory Meter 1.771,4.417 3.51,4.667 1.74,0.25 10 false *2: w/o Accessory Meter

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH

*1: w/ Accessory Meter

*2: w/o Accessroy Meter


a.

Remove the steering pad switch assembly*1 or steerieng pad switch LH*2.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspect the steerieng pad switch assembly*1 or steering pad switch LH*2.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


b.

Inspect the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION

CAUTION:

The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Be sure to read the Precaution for the SRS.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SPIRAL CABLE)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SPIRAL CABLE)
a.

Disconnect the G1 radio receiver assembly connector.


b.

Disconnect the G12 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G1-21 (SW1) - G12-6 (AU1) Always Below 1 Ω
G1-22 (SW2) - G12-5 (AU2)
G1-23 (SWG) - G12-4 (EAU)
G1-21 (SW1) - Body ground Always 10 kΩ or higher
G1-22 (SW2) - Body ground
G1-23 (SWG) - Body ground



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR