Power is supplied to the radio receiver assembly and steering pad switch assembly*1 or steering pad switch LH*2 illumination when the headlight dimmer switch assembly is in the tail or head position.
*1: w/ Accessory Meter
*2: w/o Accessory Meter
The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
*1: w/ Accessory Meter
*2: w/o Accessory Meter
Check if the illumination for the radio receiver assembly, steering pad switch assembly*1 or steering pad switch LH*2, glove box or other parts (hazard switch, transmission control switch, etc.) comes on when the headlight dimmer switch assembly is turned to the head or tail position.
| Result | Proceed to |
|---|---|
| Illumination comes on for all components except steering pad switch assembly*1 or steering pad switch LH*2. | A |
| Illumination comes on for all components except radio receiver assembly. | B |
| No illumination comes on (radio receiver assembly, hazard switch, glove box, etc.). | C |
A
B
C
| *a | Front view of wire harness connector
(to Spiral Cable Sub-assembly) |
Disconnect the G12 spiral cable sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G12-12 (IL+2) - Body ground | Light control switch TAIL or HEAD | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the steering pad switch assembly*1 or steering pad switch LH*2.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL
Inspect the steering pad switch assembly*1 or steering pad switch LH*2.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL
Inspect the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G1 radio receiver assembly connector.
Disconnect the G12 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G1-23 (SWG) - G12-4 (EAU) | Always | Below 1 Ω |
| G1-23 (SWG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
Disconnect the G5 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G5-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G5-10 (ILL+) - Body ground | Light control switch TAIL or HEAD | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG