GLOW PLUG (w/ Glow Plug Controller) > INSTALLATION |
| 1. INSTALL GLOW PLUG |
Clean the glow plug hole.
Wrap tape around a drill bit with a diameter of 4.4 mm (0.173 in.), 118.5 mm (4.67 in.) from its tip.
Insert the drill bit 118.5 mm (4.67 in.) into the glow plug hole (up to the tape) and remove any carbon deposits by turning the drill bit by hand.
Insert a drill bit with a diameter of 4 mm (0.157 in.) into the glow plug hole and remove any carbon deposits from the end of the glow plug hole by turning the drill bit by hand.
Using a 12 mm deep socket wrench, install the glow plug assembly.
| 2. INSTALL NO. 1 INTAKE MANIFOLD INSULATOR |
| 3. INSTALL NO. 1 GLOW PLUG CONNECTOR |
Temporarily install the No. 1 glow plug connector with the 4 nuts.
Tighten the 4 nuts.
Install the 4 screw grommets.
| 4. INSTALL NO. 2 MANIFOLD STAY |
Install the No. 2 manifold stay with the bolt.
| 5. INSTALL GLOW CONNECTOR BRACKET |
Install the glow connector bracket with the bolt.
Connect the No. 1 glow plug connector and attach the clamp.
| 6. INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |