DTC P0724 Brake Switch "B" Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Accelerate the vehicle to 30 km/h (19 mph) or more, depress the brake pedal and decelerate the vehicle to 3 km/h (1.8 mph) or less 5 times. | Stop light switch remains on even when vehicle is driven in GO (30 km/h (19 mph) or more) and STOP (less than 3 km/h (1.8 mph)) pattern 5 times (2 trip detection logic). |
|
| DTC No. | Data List |
| P0724 | Stop Light Switch |
| 1.READ VALUE USING GTS (STOP LIGHT SWITCH) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine / Data List / Stop Light Switch.
Read the value displayed on the GTS when the brake pedal is depressed and released.
| Brake Pedal | Display |
| Released | OFF |
| Depressed | ON |
|
| ||||
| NG | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK ECM (STP VOLTAGE) |
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| E32-8 (STP) - Body ground | Released | 0 to 3 V |
| Depressed | 11 to 14 V |
| *a | Brake Pedal Depressed |
| *b | Brake Pedal Released |
| *c | Component with harness connected (ECM) |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPLACE STOP LIGHT SWITCH ASSEMBLY |
Replace the stop light switch assembly (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON and turn the GTS on.
Start the engine.
Accelerate the vehicle to 30 km/h (19 mph) or more, depress the brake pedal and decelerate the vehicle to 3 km/h (1.8 mph) or less 5 times or more.
Confirm that the DTC is not output again.
Enter the following menus: Powertrain / Engine / Utility / All Readiness.
Input DTC P0724.
Check that STATUS is NORMAL.
| NEXT | ||
| ||