Home › ENGINE ยท 2TR-FBE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL INJECTOR ASSEMBLY


    A099091E02
  1. Install a new insulator to the fuel injector.

  1. Apply a light coat of grease or gasoline to a new O-ring and install it to the fuel injector.



    A087155E01
  1. Apply a light coat of grease or gasoline on the place where the delivery pipe touches the O-ring.

  1. To install the fuel injector into the fuel delivery pipe, push the fuel injector while twisting it back and forth.

    NOTICE:
    1. Be careful not to twist the O-ring.
    2. After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.

  1. Position the fuel injector connector so that it faces downward.



2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
  1. Apply a light coat of gasoline or spindle oil to new O-rings, and then install one to each spacer.



    G036023E01
  1. Install the 4 spacers to the cylinder head.

  1. Install 4 new injector vibration insulators to the cylinder head.

  1. Install the 2 No. 1 delivery pipe spacers to the cylinder head.

  1. Install the fuel delivery pipe together with the 4 fuel injectors with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

    NOTICE:
    Do not drop the fuel injectors when installing the fuel delivery pipe.

  1. Connect the 4 injector connectors.

  1. Connect the 4 clamps and wire harness to the delivery pipe.

  1. Connect the vacuum hose.



3. CONNECT NO. 2 FUEL HOSE
  1. Connect the No. 2 fuel hose.



4. CONNECT NO. 1 FUEL HOSE
  1. Connect the No. 1 fuel hose (Click here).



5. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
(Click here)


6. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. INSPECT FOR FUEL LEAK (for Fuel Main Tank)
  1. Connect the intelligent tester to the DLC3.

    1. Turn the ignition switch to ON.

      NOTICE:
      Do not start the engine.

    2. Push the intelligent tester main switch on.

    3. Select the Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks after performing maintenance anywhere on the fuel system.
      If there are fuel leaks, repair or replace parts as necessary.