Home › ENGINE ยท 2TR-FBE › FUEL › FUEL INJECTOR

FUEL INJECTOR > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
(Click here)


5. DISCONNECT NO. 2 FUEL HOSE


    A237737E01
  1. Disconnect the No. 2 fuel hose.



6. DISCONNECT NO. 1 FUEL HOSE
  1. Disconnect the No. 1 fuel hose (Click here).



7. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

CAUTION:
Be careful not to drop the injectors when removing the delivery pipe.



    A237738
  1. Disconnect the 4 clamps and wire harness from the delivery pipe.

  1. Disconnect the vacuum hose.



    A237739
  1. Disconnect the 4 injector connectors.

  1. Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.

    NOTICE:
    Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

  1. Remove the 2 No. 1 delivery pipe spacers.

  1. Remove the 4 injector vibration insulators.



    G038847E01
  1. Using 2 screwdrivers, pry out the 4 spacers from the cylinder head.

    HINT:
    Tape the screwdriver tips before use.

  1. Remove the 4 O-rings.



8. REMOVE FUEL INJECTOR ASSEMBLY


    G034904E01
  1. Pull out the 4 fuel injectors from the delivery pipe.

  1. Remove the 4 O-rings from the 4 fuel injectors.