Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the power window control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      10 to 14 V

      If the voltage is below 10 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    2. On-vehicle Inspection (Click here).

    3. Inspection.

      1. Inspect master switch (Click here).

      2. Inspect front passenger switch (Click here).

      3. Inspect rear switch (Click here).

      4. Inspect power window motor (Click here).


    NEXT


    5.REPAIR OR REPLACE

      NEXT


      6.PERFORM INITIALIZATION
      1. Initialize the driver side power window regulator motor assembly (Click here).


      NEXT


      7.CONFIRMATION TEST

        NEXT

        END