DTC P0412 Secondary Air Injection System Switching Valve "A" Circuit |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0412 |
|
|
| P0412 |
|
|

![]() |
| *a | Component with harness connected (ECM) |
![]() |
| Item | Content |
| ECM Terminal Name | AIDI - E1 |
| Tester Range | 5 V/DIV., 20 ms/DIV. |
| Condition | Idling |
| 1.INSPECT AIR SWITCHING VALVE ASSEMBLY |
Inspect the air switching valve assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR SWITCHING VALVE ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the air switching valve assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A9-1 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Air Switching Valve Assembly) |
Reconnect the air switching valve assembly connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR SWITCHING VALVE ASSEMBLY - AIR INJECTION CONTROL DRIVER) |
Disconnect the air switching valve assembly connector.
Disconnect the air injection control driver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A9-2 - A7-6 (VV) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A9-2 or A7-6 (VV) - Body ground | Always | 10 kΩ or higher |
Reconnect the air switching valve assembly connector.
Reconnect the air injection control driver connector.
|
| ||||
| OK | ||
| ||