Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. If the malfunction still exists even after checking and confirming that all the circuits are normal, replace the A/C amplifier.


A/C system 
Symptom
Suspected Area
See page
All functions of A/C system do not operate
A/C control assembly
Click here
A/C amplifier assembly
Click here
Harness or connector
-
Air flow control: No blower operation
Blower resistor
Click here
Blower w/ fan motor sub-assembly
Click here
A/C control assembly
Click here
Harness or connector
-
Air flow control: No blower control
Blower resistor
Click here
A/C control assembly
Click here
Harness or connector
-
Air flow control: Insufficient air comes out
Blower w/ fan motor sub-assembly
Click here
Blower resistor
Click here
A/C control assembly
Click here
Harness or connector
-
Temperature control: No cool air comes out
Volume of refrigerant
Click here
Drive belt (2TR-FE)
Click here
Drive belt (1KD-FTV)
Click here
Drive belt (1GR-FE)
Click here
Refrigerant pressure
Click here
Magnet clutch assembly (2TR-FE)
Click here
Magnet clutch assembly (1KD-FTV)
Click here
Magnet clutch assembly (1GR-FE)
Click here
Cooler compressor assembly (2TR-FE)
Click here
Cooler compressor assembly (1KD-FTV)
Click here
Cooler compressor assembly (1GR-FE)
Click here
Magnet clutch relay*1
Click here
A/C pressure switch
Click here
Air mix control cable
-
A/C control assembly
Click here
Harness or connector
-
Temperature control: Output air is warmer or cooler than set temperature or response is slow
Air mix control cable
-
A/C control assembly
Click here
Temperature control: No temperature control
Air mix control cable
-
A/C control assembly
Click here
No air inlet control
Air inlet damper control cable
-
A/C control assembly
Click here
No air outlet control
Mode control cable
-
A/C control assembly
Click here
Engine idle-up does not occur, or is continuous
Magnet clutch assembly (2TR-FE)
Click here
Magnet clutch assembly (1KD-FTV)
Click here
Magnet clutch assembly (1GR-FE)
Click here
Cooler compressor assembly (2TR-FE)
Click here
Cooler compressor assembly (1KD-FTV)
Click here
Cooler compressor assembly (1GR-FE)
Click here
A/C control assembly
Click here
A/C amplifier assembly
Click here
ECM
-
PTC heater does not function*1, *2
PTC heater relay
-
Heater switch assembly
-
Air mix control cable
-
A/C control assembly
Click here
A/C unit assembly (Max. HOT switch)
-
A/C amplifier assembly
Click here
ECM
-
Harness or connector
-
Quick heater and accessory assembly
-
  1. *1: w/ PTC heater
  2. *2: The PTC heater operation may be stopped when an electrical load of the entire vehicle is large.

Rear cooler 
Symptom
Suspected Area
See page
Air flow control: No blower operation
Rear cooler relay
Click here
Blower motor sub-assembly (rear)
Click here
Cooler control switch assembly
Click here
Harness or connector
-
Air flow control: No blower control
Blower motor sub-assembly (rear)
Click here
Blower (rear) resistor
Click here
Cooler control switch assembly
Click here
Harness or connector
-
Temperature control: No cool air comes out
Volume of refrigerant
Click here
Drive belt (2TR-FE)
Click here
Drive belt (1KD-FTV)
Click here
Drive belt (1GR-FE)
Click here
Refrigerant pressure
Click here
Cooler compressor assembly (2TR-FE)
Click here
Cooler compressor assembly (1KD-FTV)
Click here
Cooler compressor assembly (1GR-FE)
Click here
Cooler control switch assembly
Click here
Harness or connector
-