DTC P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input |
DTC P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input |

| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 3 seconds | Throttle position sensor output (VLU) is below 0.2 V for 3 seconds (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 3 seconds | Throttle position sensor output (VLU) is higher than 4.8 V for 3 seconds (1 trip detection logic). |
|


| 1.CHECK HARNESS AND CONNECTOR (THROTTLE POSITION SENSOR - ECM) |
Disconnect the throttle position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T3-1 (VC) - E29-14 (VCVL) | Always | Below 1 Ω |
| T3-3 (VTA) - E29-8 (VLU) | Always | Below 1 Ω |
| T3-2 (E2) - E29-2 (EVLU) | Always | Below 1 Ω |
| T3-1 (VC) or E29-14 (VCVL) - Body ground | Always | 10 kΩ or higher |
| T3-3 (VTA) or E29-8 (VLU) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle position sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 2.CHECK ECM TERMINAL VOLTAGE (VC TERMINAL) |
![]() |
Disconnect the throttle position sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T3-1 (VC) - T3-2 (E2) | Ignition switch ON | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Throttle Position Sensor) |
Reconnect the throttle position sensor connector.
|
| ||||
| OK | |
| 3.REPLACE DIESEL THROTTLE BODY ASSEMBLY |
Replace the diesel throttle body assembly (Click here).
| NEXT | |
| 4.READ VALUE USING GTS (ACTUAL THROTTLE POSITION) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (Click here).
Enter the following menus: Powertrain / Engine / Data List / Actual Throttle Position.
Check the movement of the throttle valve when idling the engine after starting it and when the ignition switch is ON.
| Condition | Tester Display |
| Ignition switch ON | -5 to 5% |
| Idling | 0 to 93% |
|
| ||||
| NG | |
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON for 3 seconds.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| NEXT | ||
| ||