SFI SYSTEM > VC Output Circuit |


| 1.CHECK MIL CONDITION |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.
|
| ||||
| OK | ||
| ||
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Check the communication between the tester and ECM.
| Result | Proceed to |
| Communication is possible | A |
| Communication is not possible | B |
|
| ||||
| B | |
| 3.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the throttle body with motor assembly connector.
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the throttle body with motor assembly connector.
|
| ||||
| B | |
| 4.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the accelerator pedal rod assembly connector.
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the accelerator pedal rod assembly connector.
|
| ||||
| B | |
| 5.CHECK HARNESS AND CONNECTOR |
Disconnect the throttle body with motor assembly connector.
Disconnect the accelerator pedal rod assembly connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-10 (VCTA) - Body ground | Always | 10 kΩ or higher |
| E25-4 (VCPA) - Body ground | Always | 10 kΩ or higher |
| E25-3 (VCP2) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle body with motor assembly connector.
Reconnect the accelerator pedal rod assembly connector.
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||