Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Vehicle Speed Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU receives the vehicle speed signal from the combination meter.

WIRING DIAGRAM


E225965E03


INSPECTION PROCEDURE

HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).

1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)
  1. Using the intelligent tester, read the Data List (Click here).

    HL Auto Leveling 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed / 0 to 327.67 km/h
    Actual vehicle speed
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK COMBINATION METER ASSEMBLY


    E236033E02
  1. Remove the combination meter with its connector still connected (Click here).

  1. Connect an oscilloscope to the combination meter connector.

  1. Check the waveform.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    C26-6 - Body ground
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Vehicle is driven at approximately 20 km/h (12 mph)

    OK:
    Waveform is as shown in the illustration.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)

    HINT:
    As the vehicle speed increases, the wavelength shortens.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the C26 combination meter connector.

  1. Disconnect the H27 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C26-6 - H27-16 (SPDR)
    Always
    Below 1 Ω
    C26-6 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)