Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Speaker Circuit

for Preparation Click here


DESCRIPTION

The sound signals amplified by the radio receiver assembly are sent to the speakers from the radio receiver assembly via the speaker circuit.
If there is a short in a speaker circuit, the radio receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is not a malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM


E288611E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SPEAKER CIRCUIT)
  1. *1: for RH Side
  2. *2: for LH Side
  1. Disconnect the R2 and R3 radio receiver assembly connectors.

  1. Disconnect the S16*1 and/or S15*2 front No. 1 speaker assembly connector.

  1. Disconnect the S18*1 and/or S17*2 rear speaker assembly connector.

    Standard Resistance:
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    R2-1 (FR+) - S16-1
    Always
    Below 1 Ω
    R2-5 (FR-) - S16-2
    Always
    Below 1 Ω
    R3-1 (RR+) - S18-1
    Always
    Below 1 Ω
    R3-3 (RR-) - S18-2
    Always
    Below 1 Ω
    R2-1 (FR+) - Body ground
    Always
    10 kΩ or higher
    R2-5 (FR-) - Body ground
    Always
    10 kΩ or higher
    R3-1 (RR+) - Body ground
    Always
    10 kΩ or higher
    R3-3 (RR-) - Body ground
    Always
    10 kΩ or higher
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    R2-2 (FL+) - S15-1
    Always
    Below 1 Ω
    R2-6 (FL-) - S15-2
    Always
    Below 1 Ω
    R3-2 (RL+) - S17-1
    Always
    Below 1 Ω
    R3-6 (RL-) - S17-2
    Always
    Below 1 Ω
    R2-2 (FL+) - Body ground
    Always
    10 kΩ or higher
    R2-6 (FL-) - Body ground
    Always
    10 kΩ or higher
    R3-2 (RL+) - Body ground
    Always
    10 kΩ or higher
    R3-6 (RL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
  1. Remove the front No. 1 speaker assembly (Click here).

  1. Inspect the front No. 1 speaker assembly (Click here).



NG
REPLACE FRONT NO. 1 SPEAKER ASSEMBLY (Click here)
OK


3.INSPECT REAR SPEAKER ASSEMBLY
  1. Remove the rear speaker assembly (Click here).

  1. Inspect the rear speakers assembly (Click here ).



NG
REPLACE REAR SPEAKER ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)