DTC P0489 Exhaust Gas Recirculation Control Circuit Low |
DTC P0490 Exhaust Gas Recirculation Control Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| 5 seconds after engine is started | Open or short in electric vacuum regulating valve assembly circuit for 5 seconds or more (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| 5 seconds after engine is started | Open or short in electric vacuum regulating valve assembly circuit for 5 seconds or more (1 trip detection logic). |
|
| DTC No. | Data List |
| P0489 |
|
| P0490 |
| 1.INSPECT ELECTRIC VACUUM REGULATING VALVE ASSEMBLY |
Inspect the electric vacuum regulating valve assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (POWER SOURCE) |
![]() |
Disconnect the electric vacuum regulating valve assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| V6-1 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Electric Vacuum Regulating Valve Assembly) |
Reconnect the electric vacuum regulating valve assembly connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ELECTRIC VACUUM REGULATING VALVE ASSEMBLY - ECM) |
Disconnect the electric vacuum regulating valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| V6-2 - E6-9 (EGR) | Always | Below 1 Ω |
| V6-2 or E6-9 (EGR) - Body ground | Always | 10 kΩ or higher |
Reconnect the electric vacuum regulating valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPLACE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY |
Replace the electric vacuum regulating valve assembly (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Start the engine.
Idle the engine for 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||