Home › ENGINE · 1KD-FTV › STARTING › GLOW PLUG (w/ Glow Plug Controller)

GLOW PLUG (w/ Glow Plug Controller) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK GLOW PLUG
  1. Remove the No. 1 glow plug connector (Click here).



    A241511
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    Approximately 1.0 Ω

    If the result is not as specified, replace the glow plug.

    NOTICE:
    1. Be careful not to damage the glow plugs, as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean off any oil on the terminal and Bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug, as this may cause an open circuit.

  1. Install the No. 1 glow plug connector (Click here).