ENGINE OIL COOLER > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
![]() |
Drain the coolant by removing the radiator reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug.

| *1 | Radiator Reservoir | *2 | Radiator Reservoir Cap |
| *3 | Vent Plug | *4 | Cylinder Block Drain Cock Plug |
| *5 | Radiator Drain Cock Plug | - | - |
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
| 4. REMOVE FUEL SUPPLY PUMP ASSEMBLY |
| 5. REMOVE COMMON RAIL ASSEMBLY |
| 6. REMOVE STARTER ASSEMBLY |
| 7. REMOVE OIL FILTER SUB-ASSEMBLY |
![]() |
Using SST, remove the oil filter.
| 8. REMOVE OIL COOLER COVER SUB-ASSEMBLY |
Disconnect the oil pressure switch connector.
Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.
![]() |
Remove the 13 bolts, oil cooler cover and gasket.
| 9. REMOVE OIL COOLER ASSEMBLY |
![]() |
Loosen the 4 nuts.
Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.
Remove the 4 nuts, oil cooler and 2 gaskets.