Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO JACK ADAPTER ASSEMBLY
RM33K0E _56 Audio / Visual / Telematics _043541 AUDIO / VIDEO _0213899 STEREO JACK ADAPTER ASSEMBLY A

AUDIO / VIDEO  STEREO JACK ADAPTER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the stereo jack adapter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)

CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55667 3.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

Hide 55011A 4.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55012A 5.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55405B 6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55905J 7.REMOVE CONTROL KNOB SUB-ASSEMBLY (for Manual Cooler System)

Hide 84013A 8.REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

Hide 55900 9.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 55407C 10.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

Hide 86190C 11.REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY

a.
E339747C01
0,0 0,0 false
V113147

Remove in this Direction


w/o 4WD Switch:

i.

Detach the claws and remove the No. 1 stereo jack adapter assembly.



b.
E339748C01
0,0 0,0 false
V113147

Remove in this Direction


w/ 4WD Switch:

i.

Detach the claws and remove the No. 1 stereo jack adapter assembly.



Hide 55303B 12.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 86203 13.REMOVE RADIO WIRE

E339749

a.

Detach the clamps and remove the radio wire.