Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM33K0E _59 Vehicle Exterior _043562 LIGHTING (EXT) _0219495 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 52159 1.REMOVE REAR BUMPER COVER

Hide 2.REMOVE REAR NO. 2 SEAT ASSEMBLY LH

Hide 67935 3.REMOVE BACK DOOR SCUFF PLATE

Hide 73233B 4.REMOVE REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER

Hide 62512 5.DISCONNECT QUARTER INSIDE TRIM BOARD LH

a.

Disconnect the rear side of the quarter inside trim board LH so that the connector of the rear combination light assembly LH can be disconnected.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 81560 6.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

a.
E319866

Place your hand between the quarter inside trim board LH and the body to disconnect the connector.


b.
E319867C01
0,0 0,0 false
V113147

Pull in this Direction


Detach the wire harness clamp.


c.

Disconnect the grommet and pull out the wire harness.


d.
E319868C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear combination light assembly LH.


e.

Remove the 2 screws.


f.
E319869C01
0,0 0,0 false
V113146

Place Hands Here
V113147

Pull in this Direction
V100155

Protective Tape


Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and guide to remove it.

NOTICE:

Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.