Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR
RM33K0E _59 Vehicle Exterior _043559 DOOR / HATCH _0219597 BACK DOOR N

DOOR / HATCH  BACK DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B276679C18
0.621,1.754 0.818,1.944 0.197,0.19 10 *1 2.535,1.754 2.732,1.944 0.197,0.19 10 *2
*1 Centering Bolt
*2 Standard Bolt


Centering bolts are used to mount the back door hinge to the vehicle body and back door. The back door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts (with washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 67005 1.INSPECT BACK DOOR PANEL SUB-ASSEMBLY

a.

Check that the clearance measurements of areas A to F are within the standard ranges.

B408688C01
3.708,0.146 3.865,0.344 0.156,0.198 10 false A 5.615,0.125 5.771,0.323 0.156,0.198 10 false B 4.802,0.25 4.958,0.448 0.156,0.198 10 false C 6.458,1.802 6.615,2 0.156,0.198 10 false D 5.969,2.833 6.125,3.031 0.156,0.198 10 false E 3.229,3.219 3.385,3.417 0.156,0.198 10 false F

Standard Clearance:
A 6.0 to 9.0 mm (0.236 to 0.354 in.) B 6.0 to 9.0 mm (0.236 to 0.354 in.)
C -0.5 to 2.5 mm (-0.020 to 0.098 in.) D
(Reference)
5.4 mm (0.213 in.)
E
(Reference)
5.6 mm (0.220 in.) F
(Reference)
8.1 mm (0.319 in.)



Hide 67935 2.REMOVE BACK DOOR SCUFF PLATE

Hide 67005 3.ADJUST BACK DOOR PANEL SUB-ASSEMBLY

a.
B408689

Before adjusting the upper end of the back door up and down or left and right, loosen the bolts.


b.

Tighten the hinge bolts on the body after the adjustment.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)


c.
B408690

Using a T40 "TORX" socket wrench, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.


d.

Using a T40 "TORX" socket wrench, tighten the striker mounting screws after the adjustment.

Torque:
23.5 N*m (240 kgf*cm, 17 ft.*lbf)


Hide 67935 4.INSTALL BACK DOOR SCUFF PLATE