Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
Optional components are installed.
Do not remove optional components without permission of the customer.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the windshield glass (digital TV antenna).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>WINDOW GLASS ANTENNA WIRE>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Enter the "DTV reception check" screen. Refer to Check Digital Television Reception in Operation Check.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK
As digital TV is a terrestrial broadcast, the digital TV antenna cannot receive the signal in places where the signal may not reach the vehicle, such as mountains or tunnels.
Even in areas where digital TV broadcasts for households can be received, the in-vehicle digital TV may not be able to receive the broadcast.
Check the digital TV tuner reception level.
Do not depend solely on the reception level as a reference value as it may vary depending on the signal conditions such as wave interference.
If the result changes after turning around the vehicle, it is not a malfunction, but is caused by a local weak electric field.
Digital TV tuner reception level check result indicates good reception.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Windshield Glass [Digital TV Antenna]) |
| *b | Front view of wire harness connector
(to Antenna Cord Sub-assembly) |
Disconnect the antenna connector from the windshield glass (digital TV antenna).
Disconnect the antenna connector from the antenna cord sub-assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 - B-1 | Always | Below 1 Ω |
| A-1a - B-1a | Always | Below 1 Ω |
| A-1 - Body ground | Always | 10 kΩ or higher |
| A-1a - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to No. 2 Antenna Cord Sub-assembly) |
| *b | Front view of wire harness connector
(to Navigation Receiver Assembly) |
Disconnect the antenna connector from the No. 4 antenna cord sub-assembly.
Disconnect the antenna connector from the navigation receiver assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-1 - DTV-1 | Always | Below 1 Ω |
| B-1a - DTV-1a | Always | Below 1 Ω |
| B-1 - Body ground | Always | 10 kΩ or higher |
| B-1a - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the windshield glass (digital TV antenna).
Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD GLASS>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG