The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the body ECU removal/installation are shown below.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55667
3.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH
55012A
4.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
45287
6.REMOVE LOWER STEERING COLUMN COVER
73900
7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
82730
8.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
Disconnect the front side of the 9 connectors.
Detach the 2 wire harness clamps.
Remove the 2 nuts and instrument panel junction block assembly.
Disconnect the back side of the 8 connectors.
9.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket.
89221B
10.REMOVE BODY ECU
|
Press in this Direction |
Press the 2 levers of the body ECU to release the lock.
|
Insert in this Direction |
|
Raise in this Direction |
|
Protective Tape |
With the body ECU released, insert a screwdriver with its tip wrapped with protective tape horizontally between the body ECU and junction block.
Use a screwdriver with a diameter between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).
Do not insert the screwdriver under the connector socket of the body ECU.
|
Press in this Direction |
|
Remove in this Direction. |
Press the 2 levers of the body ECU again and pull up the body ECU to remove it.
Do not touch the ECU connector.