Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
89741
1.REMOVE DOOR CONTROL RECEIVER (w/o Smart Entry and Start System)
|
Nut |
|
Connector |
Remove the nut.
Detach the guide and remove the door control receiver.
Disconnect the connector.
89740A
2.INSTALL SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Smart Entry and Start System)
|
Nut |
|
Connector |
Connect the connector.
Attach the guide to install the smart door control receiver assembly with the nut.
55302A
3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5.CHECK SRS WARNING LIGHT
6. KEY REGISTRATION (w/o Smart Entry and Start System)