Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1GD-FTV)
RM33K0E _54 Brake _043534 BRAKE SYSTEM (OTHER) _0223430 VACUUM PUMP(for 1GD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1GD-FTV)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.


PROCEDURE

Hide 11201 1.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 11821 2.REMOVE NO. 3 CAMSHAFT BEARING CAP

Hide 44773F 3.DISCONNECT UNION TO CONNECTOR TUBE HOSE

a.
C323738

Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.


Hide 25761B 4.DISCONNECT NO. 1 VACUUM TRANSMITTING HOSE

a.

Disconnect the No. 1 vacuum transmitting hose from the vacuum pump assembly.


Hide 29300 5.REMOVE VACUUM PUMP ASSEMBLY

a.
C323728

Remove the 3 bolts from the vacuum pump.


b.
C323740C01
0,0 0,0 false
V113147

Remove in this Direction


Tilt and pull the vacuum pump upwards toward the rear while avoiding the dash panel to remove the vacuum pump.

NOTICE:

Do not damage the camshaft and vacuum pump shaft.



c.

Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.


Hide 11382C 6.REMOVE CAMSHAFT OIL SEAL RETAINER

a.

Remove the camshaft oil seal retainer from the vacuum pump assembly.


Hide 29300F 7.REMOVE VACUUM PUMP UNION

a.

Fix the vacuum pump in a vise between aluminum plates.

NOTICE:

Place aluminum plates on the vise to prevent damage to the pump.



b.

Remove the union bolt, vacuum pump union and 2 gaskets.