The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the camshaft sub-assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
51410
1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
2.DRAIN ENGINE COOLANT
3.DRAIN ENGINE OIL
16571C
4.REMOVE NO. 1 RADIATOR HOSE
16711
5.REMOVE FAN SHROUD
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
89421C
7.REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR
89424D
8.REMOVE INTAKE AIR TEMPERATURE SENSOR
17940D
9.REMOVE INTERCOOLER ASSEMBLY
23701
10.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
23704
11.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
23770
12.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
11201
13.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
23670
14.REMOVE INJECTOR ASSEMBLY
11322A
15.REMOVE NO. 1 TIMING BELT COVER
13568
16.REMOVE TIMING BELT
13505
17.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
13523P
18.REMOVE CAMSHAFT TIMING PULLEY
11322B
19.REMOVE NO. 2 TIMING BELT COVER
20.REMOVE CAMSHAFT SUB-ASSEMBLY
| *a | Key Groove |
| *b | Upward |
Turn the intake camshaft sub-assembly with a wrench so that the key groove of the camshaft sub-assembly faces upward.
Uniformly loosen the 15 camshaft bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 15 camshaft bearing cap bolts, No. 1 camshaft bearing cap, 3 No. 2 camshaft bearing caps, No. 3 camshaft bearing cap, camshaft oil seal and intake camshaft sub-assembly and exhaust camshaft sub-assembly from the cylinder head sub-assembly.