Home › Steering › STEERING COLUMN › STEERING WHEEL
RM33K0E _55 Steering _047952 STEERING COLUMN _0227306 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 84610F 1.INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY

Hide 45184 2.INSTALL LOWER STEERING WHEEL BOSS COVER

a.

w/o Shift Paddle Switch

i.

Attach the guide pins and claws to install the lower steering wheel boss cover.



b.

w/ Shift Paddle Switch

i.

Install the 2 screws.


ii.

Attach the guide pins and claws to install the lower steering wheel boss cover.



Hide 45100 4.INSTALL STEERING WHEEL ASSEMBLY

a.

Align the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 84632 5.INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

Hide 84250A 6.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 45130 7.INSTALL STEERING WHEEL PAD ASSEMBLY

Hide 8.INSPECT STEERING WHEEL CENTER POINT

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45130 10.INSPECT HORN BUTTON ASSEMBLY

a.

With the horn button assembly installed to the vehicle, perform a visual check. If any of the defects mentioned below are found, replace the horn button assembly with a new one:

Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.


b.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system.

Click hereVehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE