Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84270Q
1.INSPECT LIGHT CUT RELAY
Remove the lower instrument panel sub-assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
Remove the light cut relay.
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the light cut relay.
Install the light cut relay.
Install the lower instrument panel sub-assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION