Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
83100
1.INSTALL COMBINATION METER ASSEMBLY
Connect the connector and attach the clamp.
Install the combination meter assembly with the 4 screws.
55410C
2.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55012A
3.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55667
4.INSTALL INSTRUMENT PANEL REGISTER BEZEL GARNISH
45100
5.INSTALL STEERING WHEEL ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.CHECK SRS WARNING LIGHT