Home › Vehicle Interior › METER / GAUGE / DISPLAY › CLOCK
RM33K0E _58 Vehicle Interior _043550 METER / GAUGE / DISPLAY _0227570 CLOCK A

METER / GAUGE / DISPLAY  CLOCK  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clock removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power door lock control system (Click here)

CAUTION:
B410193

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 55084E 5.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55085 6.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55844 7.REMOVE NO. 2 HEATER TO REGISTER DUCT

Hide 55670A 8.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 83910G 9.REMOVE CLOCK ASSEMBLY

a.
B437725C01
2.604,1.25 2.083,1.531 true 2.583,1.104 2.781,1.292 0.198,0.188 10 true *a
*a Protective Tape


Remove the screw.


b.

Using a screwdriver, detach the claw and remove the clock assembly.

HINT:

Tape the screwdriver tip before use.