The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the quarter window glass removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR NO. 2 SEAT ASSEMBLY
67918E
4.REMOVE REAR DOOR SCUFF PLATE LH
67935
5.REMOVE BACK DOOR SCUFF PLATE
73233A
6.REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
73233B
7.REMOVE REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
62512
8.REMOVE QUARTER INSIDE TRIM BOARD LH
73178B
9.REMOVE SEAT BELT ANCHOR COVER CAP
62639A
10.REMOVE QUARTER PILLAR GARNISH LH
73178B
11.REMOVE SEAT BELT ANCHOR COVER CAP
62472D
12.REMOVE UPPER REAR PILLAR GARNISH LH
62792V
13.REMOVE UPPER QUARTER WINDOW MOULDING LH
62720A
14.REMOVE QUARTER WINDOW ASSEMBLY LH
Be careful not to damage the quarter window assembly LH as the clips are installed to the quarter window assembly LH.
The quarter window assembly LH may fall while performing this procedure. Therefore, use suction cups to hold the quarter window assembly LH from the outside of the vehicle.
Using a knife, cut off the moulding as shown in the illustration.
| *a | Cut | - | - |
Be careful not to damage the vehicle body with the knife.
Remove the remaining moulding.
Make a partial cut in the moulding. Then pull and remove it by hand.
Put protective tape on the body panel around the quarter window assembly LH.
|
Protective Tape | - | - |
Install the suction cups to the quarter window assembly LH.
| *a | Piano Wire |
Insert a piano wire (approx. 0.6 mm) at the locations shown in the illustration, and tie objects that can serve as handles (for example, wooden blocks) to the wire ends.
Pull on the ends of the piano wire alternately and leave the clips when cutting through the adhesive.
Do not forcefully brush the piano wire against the quarter window assembly LH.
Be careful as the piano wire will break if it crosses itself.
Using suction cups, detach the 4 clips and remove the quarter window assembly LH.
Make sure that the quarter window assembly LH does not fall.
Cut the clip if it is difficult to detach.
62704A
15.REMOVE REAR QUARTER WINDOW GLASS RETAINER SUB-ASSEMBLY LH
Remove the screw.
Using a clip remover, detach the clip and remove the rear quarter window glass retainer sub-assembly LH.