The radio receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
Using this circuit, the radio receiver assembly sends power to the map light assembly (telephone microphone assembly), and the map light assembly (telephone microphone assembly) sends microphone signals to the radio receiver assembly.
Disconnect the G117 radio receiver assembly connector.
Disconnect the Q3 map light assembly (telephone microphone assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G117-4 (MACC) - Q3-15 (MACC) | Always | Below 1 Ω |
| G117-5 (MIN+) - Q3-14 (MCO+) | Always | Below 1 Ω |
| G117-19 (MIN-) - Q3-13 (MCO-) | Always | Below 1 Ω |
| G117-18 (SGND) - Body ground | Always | 10 kΩ or higher |
| G117-4 (MACC) or Q3-15 (MACC) - Body ground | Always | 10 kΩ or higher |
| G117-5 (MIN+) or Q3-14 (MCO+) - Body ground | Always | 10 kΩ or higher |
| G117-19 (MIN-) or Q3-13 (MCO-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Inspect the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Radio Receiver Assembly) |
Remove the radio receiver assembly with its connectors still connected.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G117-19 (MIN-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G117-4 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Map Light Assembly) |
Remove the map light assembly with its connectors still connected.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Turn the ignition switch to ACC.
Connect an oscilloscope to terminals Q3-14 (MCO+) and Q3-13 (MCO-) of the map light assembly connector.
Check the waveform of the telephone microphone assembly using the oscilloscope.
| Result | Proceed to |
|---|---|
| A waveform synchronized with the voice input to the map light assembly is output. | A |
| A waveform synchronized with the voice input to the map light assembly is not output. | B |
A
B