1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE FAN AND GENERATOR V BELT
27415
3.REMOVE GENERATOR WITH CLUTCH PULLEY
4.REMOVE FRONT WHEEL LH
53737B
5.REMOVE FRONT FENDER APRON SEAL LH
for 4WD, for Pre-Runner:
Remove the 6 clips and front fender apron seal LH.
for 2WD:
Remove the 5 clips and front fender apron seal LH.
88711
6.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor assembly with magnet clutch.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88704
7.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnet clutch.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
8.REMOVE COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH
Disconnect the connector.
Detach the clamp.
Remove the 5 bolts and generator bracket and compressor assembly with magnet clutch.