1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
74404B
3.REMOVE BATTERY CLAMP SUB-ASSEMBLY
Loosen the 2 nuts.
Remove the 2 battery clamp bolts and battery clamp sub-assembly.
28899
4.REMOVE BATTERY INSULATOR
28800
5.REMOVE BATTERY
74431
6.REMOVE BATTERY TRAY
16361A
7.REMOVE FAN AND GENERATOR V BELT
8.REMOVE OIL BAFFLE PLATE
Remove the bolt and oil baffle plate.
53737B
9.REMOVE FRONT UPPER FENDER APRON SEAL LH
27020
10.REMOVE GENERATOR ASSEMBLY
Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Disconnect the generator connector from the generator assembly.
Remove the 2 bolts and disconnect the wire harness together with the 2 wire harness brackets.
Disconnect the charcoal canister hose and detach the clamp.
Detach the clamp and disconnect the differential hose.
Detach the clamp and disconnect the wire harness.
Remove the bolt and differential breather bracket.
Remove the 2 bolts and generator bracket.
Remove the 2 bolts and generator assembly.