Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH
RM3250E _54 Brake _038044 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0186163 DOWNHILL ASSIST CONTROL SWITCH A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DOWNHILL ASSIST CONTROL SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 84988H 1.INSTALL DOWNHILL ASSIST CONTROL SWITCH

a.
C333206C01
0,0 0,0 false
V113147

Install in this Direction


Attach the 2 claws to install the downhill assist control switch to the lower instrument cover sub-assembly.


b.

Connect the downhill assist control switch connector.


Hide 55407C 2.INSTALL LOWER INSTRUMENT COVER SUB-ASSEMBLY

Hide 58804A 3.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 73900 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 45287 7.INSTALL LOWER STEERING COLUMN COVER

Hide 55900 8.INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 84013A 9.INSTALL INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

Hide 55410C 10.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION