51441
1.REMOVE NO. 1 ENGINE UNDER COVER
51442
2.REMOVE NO. 2 ENGINE UNDER COVER
3.DRAIN DIFFERENTIAL OIL
43420
4.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
43410
5.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
41304P
6.REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
Using SST, tap out the 2 differential side gear shaft oil seals.
41304P
7.INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
Using SST and a hammer, tap in 2 new differential side gear shaft oil seals.
0 to 0.14 mm (0 to 0.00511 in.)
| *1 | Differential Carrier | *2 | Differential Side Gear Shaft Oil Seal |
| *3 | Differential Tube | - | - |
| *a | for LH Side | *b | for RH Side |
| *c | Gap | - | - |
Make sure the LH and RH differential side gear shaft oil seals are installed to the proper locations.
Make sure that the lip of the differential side gear shaft oil seal is inserted into SST before tapping in the differential side gear shaft oil seal.
Do not damage the differential side gear shaft oil seals.
43420
8.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
43410
9.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
10.ADD DIFFERENTIAL OIL
51442
11.INSTALL NO. 2 ENGINE UNDER COVER
51441
12.INSTALL NO. 1 ENGINE UNDER COVER