Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM3250E _52 Drivetrain _038038 DRIVE SHAFT / PROPELLER SHAFT _0187312 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43420G 1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING

a.

Install a new front drive shaft hole snap ring.

NOTICE:
·

Do not damage the spline of the inboard joint.

·

The front drive shaft hole snap ring should be installed completely.




Hide 43420 2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

C317855

a.

Coat the splines of the inboard joint with differential oil.


b.

Coat the snap ring of the inboard joint with MP grease.


c.

Align the splines and tap in the front drive shaft assembly LH with a brass bar and hammer.

NOTICE:
·

Using MP grease, set the front drive shaft hole snap ring in the groove with the opening facing downwards and centered radially.

·

Do not damage the inboard joint boot, front drive shaft dust cover LH and differential side gear shaft oil seal.

·

Make sure to follow the proper handling and installation procedures. If the front drive shaft assembly LH is installed at too large an angle or slides too much, it may fall out of the groove of the tripod joint.

·

Do not tap the end of the front drive outboard joint assembly with a hammer, etc.



HINT:

Determine whether the front drive shaft assembly LH is completely tapped in by checking for changes in the tapping sound or the reaction of the brass bar.



Hide 48069 4.CONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH

Hide 5.CONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 8.INSTALL FRONT WHEEL

Hide 51442 10.INSTALL NO. 2 ENGINE UNDER COVER

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)

Hide 51441 11.INSTALL NO. 1 ENGINE UNDER COVER

Torque:
for M6 bolt : 11.5 N*m (117 kgf*cm, 8 ft.*lbf)
for M8 bolt : 28 N*m (286 kgf*cm, 21 ft.*lbf)

Hide 13.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 14.PERFORM INITIALIZATION (w/ Automatic Headlight Beam Level Control System)

Hide 15.INSPECT AUTOMATIC LIGHT CONTROL SYSTEM (w/ Automatic Headlight Beam Level Control System)

Hide 16.INSPECT HEADLIGHT AIMING (w/ Automatic Headlight Beam Level Control System)